This morning I got some new pictures, courtesy of the new machinist. They will be sent to me this week. The sample pieces are not going to be anodized because there is a minimum order of $50.00 from the place that will be doing it. Here’s some eye candy!
This entry was posted on Wednesday, September 30th, 2009 at 10:25 am and is filed under Hardware. You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.
The AL box does look good. But I wanted to share there are companies like the one I work with that have off-the-shelf enclosures for much less then it typically costs to have one machined. I know New Age Enclosures has a new 4″ x 4″ x 1.5″. In addition they are able to cut any openings you need into it. They will even build new enclosures to meet a specific size requirement.
I have looked at New Age Enclosures while searching for an enclosure to suit my needs. I did not find any that were close enough to my requirements to design a circuit board around. Typically, companies like that require a significantly higher minimum order than I can afford right now. The aluminum enclosures do look really good so far though and I’m really pleased with them!
The AL box does look good. But I wanted to share there are companies like the one I work with that have off-the-shelf enclosures for much less then it typically costs to have one machined. I know New Age Enclosures has a new 4″ x 4″ x 1.5″. In addition they are able to cut any openings you need into it. They will even build new enclosures to meet a specific size requirement.
Shauna,
I have looked at New Age Enclosures while searching for an enclosure to suit my needs. I did not find any that were close enough to my requirements to design a circuit board around. Typically, companies like that require a significantly higher minimum order than I can afford right now. The aluminum enclosures do look really good so far though and I’m really pleased with them!